The crimping tool is a tool made to crimp or connect
a connector to the end of the cable. For example, network cables and
speak to cables are created using a crimping tool for connecting the
RJ-45 and RJ-11 connectors towards the end with the cable.At
FiberStore,we stock some crimping tool to help you to made your need
cable.So,Let me tell you 9 steps to crimp a RJ45 Plug.
1, Stripping
The twisted pair twisted-pair wire stripper plastic sheath stripped of 2-3cm (Figure 1);
2, Winding Displacement
Untwist
the paired wires and separate them. Then arranged the green line as
well as the blue line at the center position, and also the orange line
about the brown line around the outer position, the development of the
left orange, blue second from left, left Three Green, fourth from left
brown line on the order (figure 2);
3, Cable Management
Carefully
peel each line (open twist), as well as the line core T568B standard
sort, especially to white and green cores in the blue and white blue
line on the cross towards the 3rd position, the fishing line core
straightened flatten, tight squeeze to look into (near) one way (figure
3);
4, Cut
The the bare twisted-pair core pressure pliers, wire cutter, diagonal pliers and other tools neatly cut, leaving just about 13mm in length (figure 4);
5, Insert
Single-handedly
crystal head, pinch the thumb and middle finger and pointer finger
pointed in the direction of the crystal head metal pins facing up,
shrapnel down. Another hand pinch the twisted pair, forced eight twisted
pair wire sequence inserted in to the crystal head slowly, and it has
been inserted into the the surface of the groove (figure5);
6, Check
Look
into the front with the crystal check out start to see the correct line
sequence; Check crystal head top view 8 cores would be the top to the
most notable (figure 6);
7, Crimp
Checked
and verified, the RJ45 Plug pushed in to the pressure line clamp slot
clenched crimping pliers, will probably be prominent externally all of
the pressure pins crystal head to the RJ-45, RJ-45 crystal head
connection is done ( figure7-9).
8, Produce a Patch Cable
Using
the same standard install crystal head, sleep issues from the twisted
pair to accomplish producing immediate access towards the network
jumper. Lack of with the T568A standard installation crystal head,
completed a crossover cable production.
9, Test
Having
a simple line in the training stage with the test device or toolbox
integrated wiring sequence tester to check the network, you will have
through straight-through cable crossover cable by open circuit, short
circuit, reverse polarity, jumper display results. RJ-45 crystal head
protective pouches prevent jumper pulled cause poor contact prior to
deciding to connect RJ-45 crystal head, crystal check out use this
pouches, need pouches inserted inside the twisted-pair cable, the
connection then put pouches.
Note:
1,Stripping can't cut through the insulation of the twisted pair wires;
2, observe the pressure line intensity should be moderate
Learning this article to know how to crimp a RJ45 Plug
and some note,do you want to Crimping your own RJ45 plugs will allow
you to create cable lengths specific to your needs. Hurry up to
FiberStore to buy the tool and cable to try,our product always has a
high quality and low price.
Source:Used The Crimping Tool To Made A RJ45 Plug
没有评论:
发表评论